The current function and cleaning method of AB glue dispensing machine

I have seen many people asking similar questions before, 'What is the future of automation equipment and AB glue dispensing machines?'? Some people have even raised the question of why automation and intelligence should be carried out to replace manual operation. The reason for this is actually very simple. It's like in the past, when we went out, we only had horse drawn carriages, and now we have three wheeled pull carts, airplanes and other transportation vehicles, which have been constantly innovating to meet the needs of the public. For automation, will unmanned workshops take the initiative to produce in the future? In response to this question, some advanced foreign enterprises are already carrying out unmanned workshops.

In the past, for traditional assembly lines, companies needed to hire many workers to operate the production of products step by step. This not only slowed down production efficiency and did not meet expected requirements, but also increased expenses, resulting in very little profit for the company. If the products were scrapped due to improper use during the operation, it would require a portion of time and materials to be remade, which would cause a lot of waste? In response to such issues, automated dispensing equipment has been developed, which can help companies reduce employee costs, control costs, and improve production efficiency, resulting in increasing profits for the company. In addition, such products are also relatively precise in operation, and the probability of scrap is very small. This is also why companies are now using automation, which has obvious benefits compared to manual operation.

For cleaning, it is also an issue that enterprises need to pay attention to. When we need to replace the rubber type, we need to first clean the pipeline. At this time, we need to close the feed valve and then open the discharge valve. After dispensing the remaining rubber in the rubber drum, we can pour the cleaning solvent into the storage rubber drum to activate the machine. At this time, we only need to press out the solvent and flush it out according to the usual operation method.

When there are no problems with the AB glue dispensing machine during testing, use a double liquid dropper or double liquid filling machine for large-scale production; The vacuum system is used to remove bubbles from the glue during the mixing process, which can sweep away any bubbles that may occur during the mixing process. Alternatively, it can be left to stand for 10-20 minutes before being used. This allows for timely removal of any bubbles that may occur during mixing, resulting in a larger amount of glue being mixed together.