How to quickly clean the automatic dispensing machine?

Customers who have used automatic dispensing machines know that when we use them, we inevitably leave some glue on the countertop, which is difficult to remove after being left behind. Over time, this glue will also affect the efficiency of our dispensing machine! How to quickly remove residual glue on the dispensing machine table? How to quickly remove residual glue on the surface of the automatic dispensing machine? How to quickly remove residual glue on the surface of the automatic dispensing machine?

1、 Remove the dispensing machine workbench with glue and place it in a dichloromethane solution for dissolution treatment. Then immerse it in the solution and the glue will naturally dissolve after a period of time. After cleaning with hydrogen peroxide, wipe clean with a dry cloth and then wipe clean with a dry cloth. Due to the thorough cleaning and low cost of using dichloromethane, this chemical substance is prone to volatilization and can cause air pollution when used in large quantities. Therefore, we should try to minimize its use.

2、 The method of using a high-pressure water gun to rinse is only suitable for cleaning when the glue has not fully solidified. That is, when the glue has just stuck to the dispensing machine, it should be immediately removed for cleaning. Otherwise, after the glue has solidified, even using high-pressure water for cleaning cannot completely eliminate the stuck glue. This method has low cost, obvious effect, and good cleaning effect, but it wastes a lot of water resources, and improper operation may cause water pollution.

3、 Using recyclable and environmentally friendly solvents for cleaning: This method is also strongly advocated by us. It is both environmentally friendly and thoroughly cleaned, without any pollution. Kind reminder: The above are the three methods for removing residual glue on the automatic dispensing machine workbench. It can be seen that the third method is currently a more practical one. Of course, we also need to find a truly suitable method based on the actual situation.