Why does the PCBA board deform when the curve PCB splitter is produced?
Release time：2022-04-18Publisher:Jeenoce
Recently, many people have consulted us on the Internet. There is no problem when using the curve PCB splitter. After using it for a period of time, the cut board will deform. What's the matter? There are always various problems. Xiaobian gives the following suggestions for engineers who need them to refer to.
1. Check the milling cutter of curve PCB dividing machine. First, check whether there is any problem with the installed milling cutter
Or remove it and reinstall it again. Then be sure to confirm whether the milling cutter is used incorrectly, because the milling cutter is also divided into many types. Remember not to make mistakes.
2. Confirm the fixture of curve PCB splitter
The produced fixture should not be too tight with the PCBA board, which will make it difficult to suck and place the milling cutter plate splitter, resulting in the deformation of the board. Finally, before production, it is necessary to confirm whether there is any problem with the fixture, and the machine can be started only after confirming that there is no problem.
3. Confirm whether the system setting of curve PCB splitter is correct
Check whether the history record in the computer system of curve PCB splitter is correct, and confirm that there is no offset before continuing production. If it is a new setting, be sure to determine the parameter settings of milling cutter / fixture, and then make production after repeatedly determining the parameters.
4. Check the matching dust collector of curve PCB splitter
Check whether the dust collector supporting the curve PCB splitting machine has too much dust collection power in production, and too much suction will also lead to deviation, resulting in the deformation of the cut PCB. The above four points about the curve PCB splitting machine must be carefully checked, and the production can be started after confirming that there is no problem. Don't be afraid of trouble. Only when the minor things are done well will there be no problem of board deformation.
