How to deal with common faults of PCB splitter?

Release time:2022-03-02Publisher:Jeenoce

PCB (printed circuit board), or printed circuit board, is one of the important components of the electronic industry. Almost every kind of electronic equipment, from electronic watches and calculators to computers, communication electronic equipment and military weapon systems, as long as there are electronic components such as integrated circuits, printed boards should be used in order to make the electrical interconnection between various components. The printed circuit board is composed of an insulating base plate, connecting wires and bonding pads for assembling and welding electronic components. It has the dual functions of conductive circuit and insulating base plate.


It can replace the complex wiring and realize the electrical connection between the components in the circuit. It not only simplifies the assembly and welding of electronic products, reduces the wiring workload in the traditional way, and greatly reduces the labor intensity of workers; Moreover, the volume of the whole machine is reduced, the product cost is reduced, and the quality and reliability of electronic equipment are improved. Printed circuit board has good product consistency. It can adopt standardized design, which is conducive to mechanization and automation in the production process. At the same time, the whole printed circuit board that has been assembled and debugged can be used as an independent spare part to facilitate the exchange and maintenance of the whole product.

图片1.png

What are the common classifications


Common PCB splitting machines mainly include laser splitting machine, high-speed splitting machine, curve splitting machine, knife walking splitting machine, guillotine splitting machine, stamping splitting machine, hand pushing splitting machine and milling cutter splitting machine.


How to deal with common faults


One possibility is that the travel counter is broken and needs to be replaced. The other possibility is that there is too much dust in the travel counter, so the dust can be removed. When the motor of PCB splitter rotates, the knife does not rotate, and the jacking wire of the coupling is loose. Turn over the rear shell and tighten the jacking wire. One possibility is that the switch of the left travel light sensor is damaged and needs to be replaced when the knife of the PCB splitter touches the left board. Another possibility is that there is too much dust in the left travel switch, so it is sufficient to remove the dust.