Analysis of the daily maintenance and service of the dividing machine

When the PCB profession was not so prosperous, the milling cutter board splitting machine used manual board splitting. However, the power of manual board splitting was low, and there were many rough edges on PCB, so the rejection rate was high. Therefore, due to the needs of social development, the dividing board machine came into being. Let's have a brief discussion with you about the daily maintenance and maintenance of the distributor.

The operation principle of the milling cutter plate dividing machine is to separate the data quickly and accurately through machinery, eliminate the raw edges of the data and reduce the invalidation rate of the data. With the changes of the times, there are more and more types of milling cutter plate splitting machines, such as washing cutter plate splitting machine, walking cutter plate splitting machine, side cutter plate splitting machine, etc., which are widely used in mobile phone profession, electronics profession, led profession, wire rod profession, etc.

During the daily operation of the distributor, it is inevitable that some losses will occur, so we should pay more attention to the maintenance, which will reduce the losses and prolong the service life.

1. after work, remember to turn off the power. Before work, clean up the waste in the tools. Some small residues may cause damage to the parts of the dividing machine.

2. regularly scrub the dividing machine. When the equipment looks shiny, people's work passion will be greatly increased. If customers participate in the factory, they will improve their impression.

3. if the machine does not work for a long time, the tool shall be disassembled and coated with engine oil. When it needs to be used, the engine oil shall be wiped off.

4. check the machine frequently to see if there is any shaking, which is usually caused by loose screws.