Does PCB splitter have to be used in SMT assembly line?

The purpose of using PCB in SMT assembly line is to improve the efficiency of operation and production. The traditional manual folding operation has low effect. It is generally mainly used in PCBA processing plants. This also adds two elements to operation and production, one is efficiency and the other is quality.

1. PCB slitter is mainly used in PCBA processing plant. Its purpose is to replace the traditional manual folding board, improve production efficiency and ensure product quality.

2. At first glance, PCB circuit board is more complex. There will be a dazzling feeling. However, in practical application, no matter what kind of circuit board, its application principle is not as complex as we think. In the practical application of PCB, there are three kinds of PCB: single-sided PCB, double-sided PCB and Multilayer PCB. In terms of the number of sides, the mechanism of single-sided printed circuit board is the simplest.

3. Of course, in the actual operation process, the staff should not only consider the safety problems of the board splitting machine manufacturer in the design and construction, but also carefully check the spacing between the upper and lower tools, and then turn on the power supply of the board splitting machine. When using the dividing machine, it is strictly prohibited to put your hand into the machine. Under any condition when the machine is running, the protective plate around the blade cannot be removed to avoid accidents. In addition, the PCB splitter is only used as a splitter and is not used for other purposes. In the whole process of use, electrostatic protection must be done well, and workers must wear electrostatic rings before operation.

4. When using the plate splitting machine, the staff must put the plate splitting groove on the fixed tool holder and move the plate splitter horizontally. Do not wear loose clothes when operating the machine. Long hair must be tied up to avoid accidents.

5. During the shutdown of the dividing machine, the staff shall pay attention to the maintenance work, pay attention to the protection of the upper and lower knife positioning plates and the upper and lower knife edges at any time, remove the sundries on the surface and inside of the machine, and check the fastening of the machine screws at any time. If the tool is not removed for a long time, the protective plate should be removed and wiped off before use. Also, before using the machine, check the circuit for damage.

6. In addition, routine maintenance and repair must be carried out at ordinary times. This depends on whether the blades are loose to avoid accidents during operation. If the PCB splitter is abnormal and needs maintenance, first ensure that the power cord is separated from the socket and operate to avoid the risk of electric shock.

The above is some relevant knowledge about PCB splitter shared by Xiaobian today. Friends who want to know more details are welcome to inquire.