What are the methods of metal surface treatment with plate splitting machine?

Chemical treatment can be carried out after treatment through the partition plate of the dividing machine: first, the acidic or alkaline solution is used to react with the oxides and oil stains on the surface of the workpiece, so as to dissolve them in the acidic or alkaline solution. The purpose of removing surface rust is to remove scale and oil stains. Chemical treatment is based on the flatness of sheet parts, but the disadvantage is that if the time cannot be properly controlled, even if corrosion inhibitors are added, excessive corrosion of steel will occur.

The mechanical treatment methods used by the plate splitting machine manufacturers: first, it includes shot blasting and shot blasting. Shot blasting is a method that uses centripetal force to accelerate the shot and project it onto the workpiece to stop rust removal and solidification. However, shot blasting has poor sensitivity and is limited by this location. There is a certain awareness when cleaning the workpiece, and it is easy to occur inside and outside the workpiece. The equipment structure is chaotic, and there are many vulnerable parts, especially the blades and other parts are worn. Based on the application of these two methods in practice, no matter which method you choose to deal with, there are many places to pay attention to.

The distributor manufacturer reminds you that if chemical treatment is adopted during operation, the surface of the distributor can be effectively and thoroughly cleaned. However, during the operation, one of the problems we need to pay attention to is to have accurate time control. Please note that the equipment is treated in an acidic or alkaline solution. If the time problem cannot be controlled, it will be easier to corrode the equipment. Therefore, based on the application of internship, it is best to invite those professionals to deal with it.

If mechanical disposal methods are used, there will be many restrictions during the internship operation. It should be known that the sensitivity of shot blasting is very poor in the process of using centripetal force to accelerate the projectile. In addition, during the internship operation, there will also be restrictions on origin, etc.

For example, use substances that have acidic or alkaline solutions, chemical reactions with oxides on the surface of the dividing machine workpiece and greasy dirt. In this case, the substance can be dissolved in acidic or alkaline solution, so the purpose of removing rust scale and grease on the workpiece surface can be achieved. However, during the internship of the daughter board machine, if you can't control the dose between the two, try not to use this method. Corrosion will occur.