Different models of circuit board splitter equipment can cut circuit boards of different shapes

The circuit board shape and connection mode are different, the products made by each customer are different, and the type of circuit board is also different. Therefore, for different circuit boards, it is best to use different styles of circuit board splitting machines for splitting operation, so as to ensure the quality and quantity, and make the purchased splitting machines more valuable at the same time.

1. For those irregular circuit boards, stamp hole boards and connection boards, milling cutter circuit board splitting machine can be used.

The milling cutter type circuit board splitting machine mainly uses the high-speed operation of the milling cutter to separate the multi connected circuit board according to the pre programmed path, replacing the cutting defects of manual breaking or V-CUT or push. It has high and accurate cutting precision, long service life, good cutting quality, no dust, no burr, low stress, safety and simplicity, improves the product quality and reduces the scrap rate. It is mainly used to divide irregular circuit board, stamp hole board and dot board. The cutting stress is less, about 1 / 10 of that of stamping type and 1 / 100 of that of hand breaking, so as to prevent chips such as ceramic capacitors from being damaged in the cutting process and avoid problems such as tin crack and component damage caused by manual folding.

2. There is also a circuit board with components. When the components are not very high and the circuit board is not large, a knife walking circuit board splitting machine can be used.

This knife type circuit board splitting machine has strong universality. When multiple boards are connected after soldering, breaking will often hurt the circuit or break electronic parts. This machine can completely reduce stress, prevent solder joint cracking and parts breaking, and improve production efficiency and quality; The upper round knife and the lower flat knife are adopted. When the board is on the lower flat knife, the switch is stepped on, and the upper round knife moves horizontally to the set point, that is, the circuit board is cut and divided, and the wire does not fall off. The incision is flat without burrs. A conveying platform can also be installed to facilitate the automatic delivery of cut PCB circuit boards.

3. For those small, thin and simple PCB boards, it is recommended to use the guillotine circuit board splitter to cut them.

The guillotine circuit board splitting machine adopts the latest pneumatic and electric lightweight design to complete the plate cutting stroke without shear stress at one time, especially suitable for cutting precision SMD or thin plate; For bow waves and micro cracks generated when there is no circular knife type plate splitting, the wedge-shaped cutter is used for linear plate splitting to minimize the shear stress, so that the sensitive SMD components and even capacitors can not be affected, and the potential quality risk of the product is minimized.

In short, different styles of circuit board splitting machines are developed and produced for different circuit board specifications and connection modes. Therefore, to choose which circuit board splitting machine to cut your circuit board products, you need to choose the one most suitable for your own circuit board cutting according to the number on the top.