How to use PCB splitter?

As an employee in the board splitting machine industry, customers often ask: can you divide any board of your board splitting machine! In fact, the board splitting machine is not omnipotent. One board splitting machine can't eat all the boards. Different boards can only be divided for different board splitting machines. That's a perfect match.

Take the PCB board in the electronic industry as an example. The PCB board can not take away the plate splitting machine, nor can it use the curve splitting machine. It is right to take away the knife splitting machine or the guillotine splitting machine. The aluminum substrate lamp strips of T5 and T8 lamps made in the LED industry can not be divided by the walking plate dividing machine, so it can only be divided by the walking plate dividing machine, and it is best to be divided by the plate dividing machine with three groups of blades, so as to prevent deformation in the largest range.

Take the PCB board with stamp holes for example. Most of these boards are from communication, digital, automobile and other industries. This kind of board can not be divided by ordinary board dividing machine, but by curve board dividing machine. Several conditions shall be met for the plate splitting of curve plate splitting machine:

1. Must be within the stamp mouth

2. The small board must have a special fixture

For those customers who have high requirements for board splitting, it is ideal for the guillotine board splitting machine to divide the PCB board, because its stress is the smallest. The PCB board with the board thickness of 0.3mm-3.5mm and the board length of 360mm can be divided by the guillotine board splitting machine.

Both the walking plate splitter and the walking plate splitter we use now are based on the V-CUT slot. There are always a small number of customers who will say that their plate has no V-CUT slot or the V-CUT slot is not obvious. At this time, we can also use the guillotine plate splitter to divide the plate.