Safety analysis to be paid attention to at the beginning of PCB splitting machining?

PCB dividing machine is an era when machines replace manual production. Especially in the electronic production industry, high-precision production requirements can hardly be met by manpower. Only relying on machines can achieve high precision and improve production efficiency.

Traditional way of electronics factory using manual production of electronic components (workpoint board folded plate), weakness, slow speed, the error is big, can not meet the high demand, but human resources is used up big, but as the machine promotion and widely used, not only meet the requirements of the electronic components quality, also improve the labor productivity, save the cost and make more development in electronics industry.

Speaking of the board machine, then about the board machine operation, there are a lot of people do not know what is going on, in fact, as long as the real to understand will find the board machine operation can be simple, and board machine manufacturers will generally provide operation training, a few hours can be operated on the machine.

1. Before the board, first check whether the knife splitting machine is normal, confirm that no error can be operated by the operator, this preferred is the knife splitting machine supplier will give you a good debugging, and then can be used, after a little check can be used.

2. Place the PCB board to be segmented, clearly distinguish the direction of the board, positive and negative sides, and position the board well to determine the segmented position, and gently press to confirm whether it is placed in place.

3. Observe whether the position of each cutting is correct. After checking, step on the knife splitter switch at the foot.

4. Cut off the power supply after PCB splitter processing.