How to maintain the automatic dividing machine?

1、 Instructions to operators;

1) Please read this manual and the operation manual of the attached machine in detail and operate according to the manual.

2) Please observe the safety regulations of this machine and ensure compliance with the regulations.

3) Please use protective equipment and clothes according to regulations.

4) Do not touch electrical equipment with too many hands.

5) During operation, if you want to arrange peripherals of boarding equipment, please ensure safety.

6) Do not put any part of your body into the equipment during operation.

7) If any abnormality occurs during operation, please stop the machine immediately and deal with it according to the exception handling method or contact our company

8) After completing the operation every day, please clean the surrounding environment of the trigger device.

9) After daily work, when you want to leave the equipment, please replace the power supply and close the main control valve according to the correct method.

10) Do not modify the emergency stop circuit and confirm the operation.

11) It is forbidden to modify the emergency stop button, safety cover, switch used to confirm the shutdown, safety photocell, safety bolt, etc.

12) It is forbidden to pull out the corresponding safety switch or cancel the safety protection function.

13) Regularly maintain and confirm whether the abnormal stop action is normal. However, at this time, it is necessary to place a notice board on the notice board that no one else is allowed to enter to inform the equipment that the equipment is currently out of service or that the automatic safety equipment is being tested. However, the security needs to be adjusted and the licensee is not subject to this restriction.

14) Regularly maintain and confirm whether the very safe detection and protection measures are normal. However, at this time, the sign that cannot be reached by others must be replaced and placed in an obvious position to inform the equipment that the automatic safety equipment is currently being tested.

2、 Restrictions on change of conditions;

1) The setting conditions of boarding equipment (voltage, current, pressure, speed, etc. on the equipment nameplate, clearly displayed settings, etc.) must be changed with the permission of the person in charge or the person in charge. When the setting conditions are changed, the values before and after the change must be adjusted and recorded.

2) The project quality index shall be determined according to the sampling inspection cycle specified in the project management rules. In case of any abnormality, immediately report to the person in charge or the person in charge and follow their instructions.

3、 Safety confirmation during maintenance;

1) During overhaul and repair, please perform the following steps to ensure safety.

2) Stop loading equipment on the board and search to ensure that all institutional facilities have been stopped in a safe position.

3) When entering the board machine equipment, please confirm the status of each safety mechanism. If necessary, a special person can be set up to monitor or pull out the safety switch lock and safety pin, and carry it with you.

4) All power supplies must be cut off, such as the main distribution box switch of the power box and the switch of the motor, and the parts with locking devices must be locked.

5) Use the specified part.

6) Use the specified products for overcurrent protectors such as fuses and maintenance parts.

7) In order to correctly operate the onboard equipment and correct the safe operation behavior, please pay attention to the nameplate of the equipment. This nameplate is very important. Please do not hurt or tear it off. If the nameplate is damaged or missing, please contact the person in charge or the person in charge.